Anthem MRX 700 User Manual download pdf (Page 46)

4.10 INFO DISPLAY

Press, Release, Press to cycle through display screens that show the following:

• Video Input: Video input jack in use.

• Audio Input: Audio input jack in use.

• Video In Configuration: Resolution of source.

• Audio In Configuration: Format of source.

• Video Out Configuration: Resolution to TV.

• F/W Info: Firmware versions of main controller, video, audio DSP, multimedia module, and date.

4.11 SOFTWARE UPGRADE – MULTIMEDIA SECTION (not available on MRX 300)

The operational characteristics of the multimedia playback via USB, Internet radio, and optional MDX 1 dock

are controlled by software installed through the USB port on the front or rear panel.

Software preparation:

1. Find out which MM version is installed by pressing INFO.

2. Go to Anthem’s web site www.anthemAV.com and locate the latest software. Proceed only if your

version is a lower number, indicating that it is older.

3. Click on the software link. You will be asked where to save a .zip file – save it to Desktop.

4. Double click or right-click on the downloaded file then extract it to Desktop.

5. In the extracted folder see Read Me.txt for the change history.

6. Copy fw_upd.bin to your USB memory device.

7. Plug the USB memory device into the receiver. The remaining instructions will appear on-screen.

4.12 SOFTWARE UPGRADE – MAIN SECTION

The operational characteristics of the receiver are controlled by software installed through the RS-232 port

on the rear panel. Updates can be downloaded from our web site and installed afterwards.

For computer and connection requirements, see section 3.11.

Software installation:

1. Find out which version is installed by pressing INFO.

2. Go to Anthem’s web site www.anthemAV.com and locate the latest software. Proceed only if your

version is a lower number, indicating that it is older.

3. Click on the software link. You will be asked where to save a .zip file – save it to Desktop.

4. Double click or right-click on the downloaded file then extract it to Desktop.

5. In the extracted folder see Read Me.txt for the change history.

6. Double click on Installer.exe. The remaining instructions will appear.

Troubleshooting:

If the installer keeps returning a message saying that the processor is not found, make sure that the serial

port on your computer isn’t being used by another application – you must go into the application that is using

it to turn off the serial port.

4. OPERATION continued …

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52

No comments

Anthem MRX 700 User Manual Page 46